Differences

This shows you the differences between two versions of the page.

--- ycsserver:dr2x:dr2x_configuration [2021/03/02 00:10] – [Recommended configuration of the DR-2X repeater] dg9ffm
+++ ycsserver:dr2x:dr2x_configuration [2024/10/12 18:53] (current) – external edit 127.0.0.1
@@ Line 17: / Line 17: @@
   * Use "Write to Device..." to write configuration to the repeater
-  * //The IMRS communicates with the LAN-01A via specified port 21110 (default). DO NOT CHANGE the “21110” UDP port setting. Also you should set the router firewall to open the UDP port “21110”.When using a router to connect the PC to the Internet, the UDP port must go through the router as well; however, communications using this port is generally prohibited on commercially available routers in the default setting.Therefore, if you are using a router, make sure that the port is “open” for passing UDP traffic.//
+  * //The IMRS communicates with the LAN-01A via specified port 21110 (default). DO NOT CHANGE the “21110” UDP port setting. Also you should set the router firewall to open the UDP port “21110”.When using a router to connect the PC to the Internet, the UDP port must go through the router as well; however, communications using this port is generally prohibited on commercially available routers in the default setting.Therefore, if you are using a router, make sure that the port is “open” for passing UDP traffic inbound and outbound.//
   * On “Destination Repeater's Information” screen, click the button "001". The “Destination Repeater Setting” screen appears.
@@ Line 24: / Line 24: @@
   * Enter the IP address of the desired YCS server
+    *  //for example://
+      * //using Internet: **185.228.139.209** = YCS262 (DE C4FM Germany)//
+      * //using Hamnet: **44.148.237.4** = YCS262 (DE C4FM Germany)//
   * Use "Write to Device..." to write configuration to the repeater
@@ Line 29: / Line 34: @@
 ==== DG-ID configuration of the DR-2X ====
+// => Please follow the instructions carefully so that correct operation is possible with the correct configuration.// \\
+\\
 The next step is to configure the repeater's own DG-ID (01) and the desired DG-ID's to be connected to the YCS server.\\