Differences

This shows you the differences between two versions of the page.

--- ycsserver:dr1x:dr1x_configuration [2021/10/05 10:49] – [Wiring of the connection cable] dg9ffm
+++ ycsserver:dr1x:dr1x_configuration [2024/10/12 18:53] (current) – external edit 127.0.0.1
@@ Line 4: / Line 4: @@
 \\
 However, the DR1-X with its [Control I/O] connector offers the option of using an external repeater control, for example an MMDVM modem. //**(Attention: DR1-XFR not supportet)**//\\
-This expansion can be carried out without interfering with the repeater hardware and turns the dr1-x into a full-fledged mmdvm repeater, which now also supports DG-ID (System Fusion II) and can be connected directly to a YCS server.\\
+This expansion can be carried out without interfering with the repeater hardware and turns the DR1-X into a full-fledged mmdvm repeater, which now also supports DG-ID (System Fusion II) and can be connected directly to a YCS server.\\
 \\
 \\
@@ Line 50: / Line 50: @@
 \\
 ==== Configuration of DR1-X ====
-Please note the information in the following documents:\\
-  * DR-1 REPEATER, BASE and REMOTE Mode Operations
-    * {{ :ycsserver:dr1x:dr-1_repeater_base_and_remote_mode_operations.pdf |}}
+  * Set **"UP LINK"** to **Packet Speed 9600bps**
-  * STM32_DVM_USB Schematic
+  * Set **"Deviation"** to **WIDE**
-    * [[http://www.repeater-builder.com/products/pdfs/STM32_DVM_v4.pdf]]
+  * Set **"Remote Operation"** to **ON**
+\\
+Further useful information for the configuration of the DR1-X and instructions for level adjustment of the MMDVM board with the help of pistar can be found in the following document:\\
+  * RB_DR-1x setup.pdf
+    * [[http://www.repeater-builder.com/products/pdfs/RB_DR-1x%20setup.pdf]]
 \\